How to Remove Mirror

As dimension and depth is added to the room because of the wall mirror and appearance and the visible size is also enhanced. Non visible framework is used in order to hold the glass mirror and it is basically held in its place because of a strong adhesive. Removing the mirror from the wall is little hard and difficult without damaging the wall and breaking the glass.

Following is the method of how to remove the mirror from a wall. Following is the method of how to remove mirror from a walls.

Procedure:

How to remove mirror?

Material Required:

.    Packing tape or painter's tape
.    Piano wire
.    Putty knife
.    Wood shims
.    Hammer

Instructions to Follow:

Step: No: 1:

A painter’s tape or a wide packing tape is used that completely covers the front of the mirror. With the help of this the mirror is not going to smash into small bits and a little protection is added in case of any crack on the mirror that prevents the pieces to fall on the ground.

Step: No: 2:

From the roll the length of the piano wire is unwrapped long enough so that the width of the mirror is spanned plus a little feet on one or the other end in order to grip onto it.

Step: No: 3:

Piano wire slides behind the highest part of the mirror and working from the one top most corner as compared to the other and this helps to lose the mirror from the wall. In order to develop a good hold on the piano wire, heavy work gloves should be used that protect the hands. A putty knife is shoved behind the glass if you are not capable to begin the piano wire behind the mirror. Shoving a putty knife is to make a minor gap or break, twisting it to make space.

Step: No: 4:

All the ends of the piano wire are held from above the glass by means of the wire that is behind the mirror. Ask for help in order to grip one end when the mirror is large and you are going to hold the other end. You need to pull straightly downwards whereas; sawing or cutting somewhat back as well as forth and wire should also be kept nearer to the wall as much as you can instead of pulling it away from the wall.

Step: No: 5:

You need to carry on your work towards the way downwards, wriggling the wire till the glass works free as of the wall. Again, ask for help in order to grasp the mirror’s face lightly so that it is not going to crash. If some of the portions are hard to slice through, wood shims are tapped softly behind the mirror’s part where you are working with the hammer. No need to push it far otherwise they might cause the mirror to break.

Step: No: 6:

Piano wire is wiggled from the numerous angles till the glass comes off the wall.